Dreams

In order to increase the productivity of carpentry, it is important that the axe be properly prepared that everyone understands. But just a sharp axe won't make you a " socialist competition " . It should be not just sharp, it's got to be buried. We'll figure out how to do this and what's the right axe for different purposes.

Axe stitch angle and width
Two points must be taken into account in preparing the axe for use: the angle of the end and the width of the phase. The optimum angle of the windows each chooses on the basis of personal experience. The fact is that the right angle depends on four main factors:
First of all, from the tree breed. It is clear that different woods have different ties.

Second, from the condition of the wood: dry or wet.
Thirdly, from the nature of the work to be performed by the axe (single, stunting, etc.).
And finally, fourthly, from the stamp of steel made by the axe.

It is therefore possible to make only " mid-point " recommendations. If you need to cut dry wood, the angle should be between 25 and 30 degrees. A 20-degree angle would be better for a freshly cut wood. The less the angle, the faster the axe becomes stupid.

The breadth of the phase also affects the axe productivity. However, it is rarely changed. This is done by the metal sheep. The method used to be " blade " . The axe was carried by a blacksmith and he gave him a second youth. Modern production does not “make” itself a good cow. So the people's laughter planted another option. The axe is quoted as a double launch. The first angle of about 15 degrees, and the sharp (second angle) itself, is downloaded by an average value (25 degrees).

How to pull ax.
The process itself requires the utmost attention. The process takes little time when electro-processing is used, but the metal is overheating, which does not affect the hardness of the refrigerating axe. The first thing that needs to be done is to minimize the beatings of the target circle. In the process of closing, the state of the circle must be kept under constant review and regularly corrected. Only in this case can we make a good point.